An engine problem is one of the most serious issues a pilot can face, whether you're flying a piston single or a twin-engine jet. It demands quick thinking, solid procedures, and good judgment. Knowing what to do — and when — can be the difference between a safe return and a dangerous situation.
Let’s break down what engine problems really mean, how to handle them, and when it’s safe to attempt a restart.
What is an engine failure?
An engine failure is the partial or total loss of power produced by the engine. This could happen:
Suddenly (complete shutdown, seizure, or fire)
Gradually (rough running, abnormal indications, or power loss)
Failures can be mechanical, electrical, or fuel-related — and can occur during any phase of flight.
Common causes of engine problems
Fuel starvation or contamination
Oil pressure loss or overheating
Mechanical failure (cylinder, valves, turbine blades)
Bird strike or FOD ingestion
Ignition system malfunction
Pilot error (misconfigured fuel tanks, improper mixture)
Recognizing symptoms early — unusual sounds, vibration, instrument warnings — helps you act before a full failure occurs.
Standard procedures for engine trouble
While exact checklists vary by aircraft, most procedures follow the same basic logic:
1. Maintain aircraft controlFly the airplane. Set the best glide speed if necessary.
2. Identify the problemCheck instruments: oil pressure, fuel flow, RPM, EGT, etc. Listen and feel for abnormal sounds or vibrations.
3. Run the checklistEvery aircraft has an Engine Failure in Flight or Engine Malfunction checklist. It usually includes:
Carb heat (if applicable)
Fuel selector
Mixture and throttle
Magnetos
Fuel pump
This process helps determine whether it’s a fixable issue or if a shutdown is necessary.
When to attempt a restart
A restart should only be attempted if you’ve diagnosed the cause and believe it’s safe and logical to try. Examples:
Switched to an empty fuel tank by mistake
Engine flooded during start
Temporary vapor lock
Restart procedures typically include:
Switching fuel tanks
Turning on fuel pump
Setting mixture, throttle, and magnetos correctly
Engaging the starter if RPM permits
Never waste time on repeated restart attempts if you're losing altitude. Your priority is finding a safe place to land.
In twin-engine aircraft
The focus shifts to identifying the failed engine and securing it to prevent asymmetric thrust issues. Pilots use:
Engine instruments
Rudder inputs (dead foot = dead engine)
Feathering the prop (if equipped)
Shutdown checklists and single-engine performance management
Flying on one engine is difficult — especially on takeoff or climb. That’s why simulator training and quick identification are key.
What if the engine fails after takeoff?
This is one of the most dangerous situations. Below a certain altitude (the “impossible turn” zone), your only option may be to land straight ahead or slightly off-centerline. Trying to turn back to the runway can be fatal unless you've trained for it at a safe altitude.
If there's enough altitude:
Pitch for best glide
Pick a spot to land
Run the engine failure checklist quickly
Prepare for a possible forced landing
Engine problems are rare — but not impossible. The key is staying calm, using checklists, and making decisions based on altitude, options, and time.
Remember:Fly the airplane. Follow the checklist. Focus on the outcome.Train often, think ahead, and always have a plan B.